Collingwood H2 Lite T Fire Rated LED Downlight Brushed Steel

In-Depth Look

The Collingwood H2 Lite T is a compact, fire rated downlight with an integrated LED, so there is no separate lamp to choose.

Integrated LED Advantage

With a GU10-based downlight, the quality of light depends entirely on which lamp the installer or homeowner chooses. The H2 Lite T removes this variable by building the LED module into the fitting. The result is a consistent 55-degree beam angle and 4000K colour temperature across every fitting on the ceiling.

Bathroom and Wet Area Suitability

The H2 Lite T is IP65 rated and retailers list it for use in bathroom zones. Check the Collingwood data sheet for the zones it is rated for and the installation requirements before fitting it above a bath or shower. Being both fire rated and IP rated means one fitting can cover both needs on a bathroom ceiling.

Verdict

The Collingwood H2 Lite T combines an integrated LED, a fire rating, IP65 protection and dimming in a compact fitting. Check the data sheet for the fire rating, bathroom zones, light output and dimmer compatibility before specifying it.

How It Compares

The Collingwood H2 Lite is an integrated LED fire-rated downlight, which means the light source is built in and there is no separate lamp to replace. The version on this page is the 4000K brushed steel one. The range also includes 3000K and 4000K versions, at 460 lumens and 490 lumens respectively, with a listed power of 4.3W.

It fits a cut-out of 64 to 72mm, is fire rated as standard, and is rated IP65 and listed for UK bathroom zone 1. It is dimmable, can be covered by insulation, has a 55 degree beam and comes with a 10 year guarantee.

Colour temperature is the other choice. 3000K is a warmer white, and 4000K is a cooler, more neutral white. Choose one colour for a whole room so the lights match.

Before ordering, count the lights you need for the room and check the spacing against the beam angle. A 55 degree beam spreads light fairly widely, so downlights placed too far apart can leave darker patches between them. Check the room layout against the maker’s guidance, and remember that circuits, drivers and dimmers also need to suit the lights. Wiring should follow the manufacturer’s instructions, and a competent person should do it where required.

Common Questions

What does fire rated mean for a downlight, and where is it needed? A fire-rated downlight is designed so that the hole cut for it does not weaken the fire resistance of the ceiling around it. This matters where there is a room or living space above. Check Building Regulations and the manufacturer’s instructions, and use a competent person where required.

How do I measure the cut-out, and can the hole be too big? Measure the diameter of the hole you cut. This fitting takes 64 to 72mm, so a hole within that range works. A hole larger than the stated range may leave a gap or stop the fitting from holding properly. Use a hole saw of the right size and check before cutting.

Can I use it in a bathroom, and which zones? The maker lists it as IP65 and suitable for UK bathroom zone 1. Check the data sheet for the exact zone information before fitting, and follow the manufacturer’s instructions. Electrical work in bathrooms should be done by a competent person where required.

What happens when an integrated LED fails? With an integrated unit there is no lamp to swap, so the whole fitting is generally replaced. The manufacturer’s 10 year guarantee applies; check its terms with Collingwood or your supplier.